•
Remove the four screws that secure the hard-drive assembly to the
computer base.
•
Using the pull-tab, slide the hard-drive assembly to disconnect it from
the connector on the system board.
•
Lift the hard-drive assembly out of the computer base.
CAUTION:
antistatic packaging (see "Protecting Against Electrostatic Discharge" in the
safety instructions that shipped with your computer).
Hard drive 1
1
pull-tab
3
screws (4)
Hard drive 2
28
Hard Drive(s)
When the hard drive is not in the computer, store it in protective
2
hard-drive assembly
2
1
3