Operation - DeWalt DCL510 Original Instructions Manual

E ngl i s h
inserting and removing the Battery Pack
from the tool (fig. 2)
NotE: Make sure your battery pack (f) is fully charged.
to install the Battery PaCk into the tool handle
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into place.
to reMoVe the Battery PaCk froM the tool
1. Press the release button (g) and firmly pull the battery pack out of
the tool handle.
2. Insert battery pack into the charger as described in the charger
section of this manual.

oPeration

instructions for use
WARNING: Always observe the safety instructions and
applicable regulations.
switch (fig. 1)
To turn the light on, press the switch (a). To turn it off, press the switch
again.
Pivoting head (fig. 1, 3)
The pivoting head (c) provides light in any direction by rotating 180˚ in
both directions.
Magnets, Belt hook and stand
CAUTION: When magnet and belt hook is in use, do not
shake light. Personal injury or property damage may occur.
CAUTION: When light is hung by the magnet and belt
hook, do not shake the light or object that it is hanging
from. Do not hang the light from any electrical wires or
18