Charging Process - DeWalt DCL510 Original Instructions Manual

E ngl i s h
Chargers
The DCB105, DCB107 and DCB112 chargers accept 10.8V D
XR Li-Ion batteries.
These chargers require no adjustment and are designed to be as easy
as possible to operate.
Charging Procedure (fig. 2)
1. Plug the charger (h) into an appropriate outlet before inserting
battery pack.
2. Insert the battery pack (f) into the charger. The red (charging) light
will blink continuously indicating that the charging process has
started.
3. The completion of charge will be indicated by the red light
remaining ON continuously. The pack is fully charged and may be
used at this time or left in the charger.
NotE: To ensure maximum performance and life of Li-Ion batteries,
charge the battery pack fully before first use.

Charging Process

Refer the tables below for the state of charge of the battery pack.
State of charge–DCB105
charging
fully charged
hot/cold pack delay
replace battery pack
State of charge–DCB107 and DCB112
charging
fully charged
hot/cold pack delay ––
10
Save tHeSe inStructionS
– – – –
–––––––––––
–– – –– –
•••••••••••
–– –– –– ––
––––––––––––––––––––
–– ––
––
–––––––
WALT
e