Table of Contents
Advertisement
setup screen
WDR Setup
It displays a sharp image of the objects in a scene where both bright and dark areas exist.
1.
Select <Backlight>.
2.
Set <Mode> to <WDR>.
3.
Specify the <WDR level>.
M
WDR is available only if <Megapixel
Mode> is set to <2-Megapixel>.
If WDR mode is active, the shutter mode
cannot be changed. Data transfer via the
network is available at up to 15 fps.
If the WDR mode is active, a moving object can cause an afterimage on the screen.
Exposure Setup
You can adjust the exposure level of the camera.
1.
Select <Exposure>.
2.
Select each item and set it properly.
•
Brightness : Adjust the screen
brightness.
•
Shutter mode : Adjust the electronic
shutter of the camera.
-
ESC (Electronic shutter control) :
Adjust the shutter speed
automatically according to the
ambient brightness.
-
Manual : Adjust the shutter speed
of the camera manually.
-
A.FLK (Anti flicker) : This will prevent the screen from flickering.
•
Shutter speed : Control the shutter speed manually.
•
SSNR3 : Specify the use of noise reduction.
•
SSNR3 level : Adjust the noise reduction level.
•
Sens-up mode : Automatically senses the darkness level at night or in a low
contrast scene and extends the accumulation time accordingly for a bright and
sharp image.
If you set the shutter mode to Manual/A.FLK, SENS-UP mode will be deactivated.
The greater the video accumulation factor is, the brighter the screen is but the afterimage of a
moving object grows accordingly.
52_ setup screen
Advertisement
Table of Contents
