Table of Contents
Advertisement
Adjusting the spindle
Setting up the spindle
10. Press the
The tool holder stops above the material to be engraved exactly where the engraving should start.
11. Set the spindle pressure with the knob
in diagram 36).
To engrave without a nose, the pressure knob
To engrave with a nose, the setting depends on the hardness of the material, on the cutter width and on the surface
state of the plate selected (if the nose is likely to scratch the object, reduce the pressure).
12. Set the regulating nose
13. Unscrew the index finger
Line up the 0 of the scaled knob with the index finger
unscrewed in such a way that the index finger blocks it.
2 mm
IS200 TX machine . 26
key and the
5
To engrave with a nose, nous vous conseillons to unscrew the pressure knurl on
spindle (2) until you can see the second mark (diagram 36).
in place on the spindle and tighten the nose nut.
then unscrew the scaled knob
0
5
key straight after.
(the tightening direction is indicated by the arrow
2
0
must be completely tightened so that the spindle is rigid.
5
(diagram 37).
. The scaled knob should be
2 mm
0
First contact
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the IS200 and is the answer not in the manual?
Questions and answers
Como codificar la maquina isi200 para que ponga lista para recibir
To set up the GRAVOGRAPH IS200 machine to be ready to receive:
1. Turn on the Machine: Switch the IS200 TX machine on (switch in position 1).
2. Boot Process: A message will appear on the screen: "Boot Program X.X RAM: 2M".
3. Initial Display: The LCD screen will then show "<< GRAVOGRAPH >> VERSION XX.XX" for about 3 seconds.
4. Language Selection: During this time, press "LANGUAGE: ENGLISH" to change the language if needed.
- If the language selection screen does not appear, turn the machine off, wait a few seconds, turn it back on, and restart the configuration process.
5. Confirm Language: Press the button multiple times to select the desired language. The chosen language will be displayed.
6. Validate Selection: Press the confirmation button to finalize the language setting.
After completing these steps, the IS200 TX machine is set up and ready to receive further commands.
This answer is automatically generated
@Alberto ulldemolins