Error Messages - Philips Allegiant LTC 8500 Series Instructions For Use Manual

Error 01 - Invalid camera request
The camera number entered from the keyboard does
not exist. If using the optional TC8850 Graphical
User Interface software or the optional TC8x59
Master Control Software, make sure the number
exists in the Camera Identification Table. Download
the table to be sure.
Error 02 - Invalid monitor request
The monitor number entered from the keyboard does
not exist.
Error 03 - Locked remote device
The remote device requested cannot be controlled
because it is locked by a user with equal or higher
priority. Check with the other users or request that a
higher priority user unlock the remote device.
Error 04 - Monitor locked
The monitor requested cannot be accessed because
it is locked by a user with equal or higher priority.
Check with the other users or request that a higher
priority user unlock the monitor.
Error 05 - Remote device access restricted
Remote locked out by Remote Lock Out Table.
Error 06 - Monitor Access Restricted
Monitor locked out by Monitor Lock Out Table.
Error 10 - Access denied
A function was requested for which your user priority
is too low. Only a Priority 2 user or a supervisor with
Priority 1 may access this function.
Error 11 - Access denied
A function was requested for which your user priority
is too low. Only a supervisor with Priority 1 may
access this function.
Error 15 - Invalid user function
The function number requested from the keyboard is
invalid. Refer to the User Function Table for a listing
of the valid user function numbers.
Error 20 - Acknowledge denied
The ACKNOWLEDGE button has been pressed by a
user without the authority to acknowledge alarms.
Error 21 - Incorrect acknowledge
In order to properly acknowledge an alarm event, the
keyboard must be switched to a monitor that is
displaying the alarms.
Error 22 - Acknowledge disabled
Alarms on this monitor can not be acknowledged,
because that capability has been disabled by the
system programmer.

ERROR MESSAGES

Error 23 - Camera not in alarm
The camera displayed on the monitor is not an alarm
video;
acknowledged.
Error 24 - Keyboard not enabled for acknowledge
This keyboard may not acknowledge alarm video on
this monitor; it has been disabled by the system
programmer.
Error 25 - Alarm switcher running
Alarm video may only be acknowledged if the alarm
switcher is not running; press HOLD to stop the
switcher.
Error 50 - SEQUENCE not available
The user tried to load a switcher sequence that does
not exist. This is a good way to tell from the
keyboard which sequence numbers are unused when
desiring to add one.
Error 51 - SEQUENCE request
A request was made to load an ABSOLUTE type
sequence without the keyboard being on one of the
monitors in that sequence. Because inadvertent
loading of monitors should be avoided, the user is
required to switch his keyboard to one of the
monitors used by the sequence. The PROGRAM
mode may be used to review what monitors are used
in the sequence.
Error 52 - SEQUENCE request
A request was made to load a RELATIVE type
sequence on too high of a monitor number; the
monitors used by the sequence would extend past
the highest monitor. Try switching to a lower monitor
number before Loading the sequence.
Error 53 - Switcher empty
The user has tried to control a sequence using the
NEXT, PREV, RUN, or HOLD keys without there
being a sequence loaded.
Error 55 - SEQUENCE priority
The switcher sequence being requested or cleared
requires monitors that are in use by a user of equal
or higher priority. Contact a user with higher priority
or have the system administrator clear the monitors
in question.
Error 56 - SEQUENCE request
The user has tried to load a sequence that is being
edited in the PROGRAM mode. Once editing is
completed, the sequence may be loaded.
71
only alarm-generated video can be