Stand-Alone Programmer Manual Control; Operation Via Cyclone Pro Buttons - Freescale Semiconductor PE Micro Cyclone Pro User Manual

CYCLONE PRO
6

STAND-ALONE PROGRAMMER MANUAL CONTROL

The Cyclone PRO must be configured before it may serve as a Stand-Alone
Programmer for HC08, HCS08, RS08, HC(S)12(X), ColdFire V1 targets. The
user may manually control the Cyclone PRO: via the buttons/LEDs, LCD
menu, or via PC software. The target power management schemes remain
the same for each control method.
6.1

Operation Via Cyclone PRO Buttons

There are five (5) buttons on the top of the Cyclone PRO which are used for
stand-alone programming and to navigate the LCD menus. They are specified
as follows.
Button
START /
AUX /
MENU / [SELECT]
CANCEL
RESET
6.1.1 Cyclone PRO LED Indicators
The Cyclone PRO has eight (8) LEDs to indicate the current operation stage.
LED
Power
Standby
Security
Erase
Program
48
Function
Start executing the tasks pre-configured into the
Cyclone PRO.
Menu Mode: Navigate upwards in LCD menu.
Perform auxiliary function (stand-alone verification).
Menu Mode: Navigate downwards in LCD menu.
Toggles ON/OFF the Target Board Power.
Menu Mode: Select highlighted item in LCD menu.
Cancel the tasks being executed and go back to the
standby state.
Hardware reset of the Cyclone PRO.
FUNCTION
Indicates that the target board power is connected.
The Cyclone PRO is waiting for instructions.
The Cyclone PRO is trying to pass the target security
and enter monitor mode (for MON08 only).
The Cyclone PRO is erasing the target Flash/
EEPROM.
The Cyclone PRO is programming the target Flash/
Cyclone PRO User Manual