Tx/Rx Menu; Mode; Antenna Att; Fm Deviation - Yaesu FT5Dr Advance Manual

TX/RX Menu

1 MODE

1 ANTENNA ATT

If the signal from the remote station is too strong or, a strong signal exists nearby that
interferes with reception, use the attenuator (ATT) function to reduce interference.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
OFF
ON
Remark The default setting: OFF

2 FM DEVIATION

The FM deviation can be set to half of its usual level.
Select [WIDE] for normal amateur operation.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
WIDE
NARROW
Remark The default setting: WIDE

3 RX MODE

Manually switch to a suitable mode (radio wave type) according to the frequency band.
Press and hold the [F
For details, refer to "Fixing the Communication Mode" in the Operating Manual.

2 DIGITAL

1 DIGITAL POPUP

Set the time duration to display the remote station information such as the call sign, on
the LCD.
1. Press and hold the [F
2. Rotate the DIAL knob to select the desired setting.
OFF
BAND 2 s
to BAND 60 s
(seconds)
BAND CONTINUE The remote station information is continuously displayed.
Remark The default setting: BAND 10 s (seconds)
] key  touch [TX/RX]  [1 MODE]  [1 ANTENNA ATTN]
MENU
Disable the attenuator (ATT) function OFF.
Enable the attenuator (ATT) function ON.
The amount of attenuation by the attenuator (ATT) is about 10 dB.
] key  touch [TX/RX]  [1 MODE]  [2 FM DEVIATION]
MENU
Normal FM mode (Full deviation)
Narrow FM mode (Half deviation)
] key  touch [TX/RX]  [1 MODE] → [3 RX MODE].
MENU
] key  touch [TX/RX]  [2 DIGITAL]  [1 DIGITAL POPUP]
MENU
The remote station information is not displayed.
Set the time duration to display the remote station information
(2 to 60 seconds).
BAND 2 s / BAND 4 s / BAND 6 s / BAND 8 s / BAND 10 s /
BAND 20 s / BAND 30 s / BAND 60 s
48