Replacing The Memory; Start Up - Power One AURORA PVI-6000-OUT-US-W Installation And Operation Manual

User Manual
(PVI-6000-OUTD-US-W Rev.2.0)
3.10

Replacing the memory

All energy output logs are stored in this memory. If you need to replace the
inverter, the memory can be removed from the old unit and placed into the new
inverter. This way, you will retain all system logs and keep saving future daily logs
into the same memory (see Fig. 15)
WARNING:
personnel.
WARNING:
correctly into the board connector.
4

START UP

WARNING: Do not place any items on AURORA during operation.
WARNING: Do not touch the heat sink when the inverter is operating,
as some parts may be hot and cause burns.
Fig. 15 Inverter memory
This component should only be replaced by qualified
Make sure to insert the memory connector pins
Page 29 of 77