Canon VB-C300 Operation Manual page 86

Log Messages
● B103 Client forcibly disconnected (notice)
Message
%1
%2
Explanation
● B301 Transmission audio device error (err)
Message
%1
%2
Explanation
Countermeasure
● B401 Audio device initialization failed (crit)
Message
%1
Explanation
Countermeasure
● B402 Audio Server initialization failed (crit)
Message
%1
Explanation
Countermeasure
● B403 Setting change failed (crit)
Message
%1
Explanation
Countermeasure
■ System Log Messages
● S004 System start and stop (info)
Message
%1
Explanation
● S005 System setting changed (info)
Message
Explanation
● H043 User specification error (notice)
Message
%1
%2
%3
Explanation
4-6
%1 request denied [%2]
Client host IP address
Rejection type (41 | 43 | ...)
Although connection was allowed at the start of session, the settings have been changed to ban
the client access and the client has been forcibly disconnected from the Audio Server (the rejection
types are the same as B102).
cannot use audio device for tx [%1 : %2]
Error process (ld | buff)
Error number
An audio device error has been detected.
Reboot the Camera. If the problem persists, it is an Audio Device failure. Call for service.
audio device initialization error [%1]
Error number
The Audio device failed to initialize itself. The Audio Server stops.
Reboot the Camera. If the problem persists, it is an Audio Device failure. Call for service.
wvaudio initialization error [%1]
Error number
The Audio Server failed to initialize itself. The Audio Server stops.
Reboot the Camera. If the problem persists, it is an Audio Server failure. Call for service.
cannot set config [%1]
Error number
Update of settings failed. The Audio Server stops.
Reboot the Camera. If the problem persists, it is an Audio Server failure. Call for service.
%1 webview
Start (starting) or stop (stopping)
This message indicates start or stop of the Video Server (webview).
System settings updated
The settings have been changed without reboot.
%1: user %2 not found: %3
Client host IP address
User Name
URL
An unknown user has been specified in user authentication.