Log Messages; The Vb-C300 Log Messages - Canon VB-C300 Operation Manual

Log Messages

The VB-C300 Log Messages

The log messages are classified into the following five categories.
Classification
crit
err
warning
notice
info
■ Camera Messages
● A001 Camera start failure (crit)
Message
%1
Explanation
Countermeasure
● A002 Protocol initialization failure (err)
Message
%1
Explanation
Countermeasure
● A011 Camera control device error (warning)
Message
%1
%2
Explanation
Countermeasure
● A012 WebView Livescope client start and stop (info)
Message
%1
%2
%3
Explanation
● A016 Video data transmission quantity (info)
Message
%1
%2
%3
%4
%5
Explanation
4-4
Level Error level
Error A critical failure at software level (task stops).
Error A failure affecting camera operation (task continues).
Warning A failure not affecting the camera operation.
Warning A failure external to the system.
Information Information concerning normal operation.
no %1 installed
sources | protocols
Camera failed to capture images or initialize the protocol and could not start.
Reboot the camera. If the problem persists, it is a camera failure. Call for service.
%1 protocol not installed
Protocol type (LS/H)
The camera failed to initialize the WebView. Configuration data may be destroyed.
Restore the factory default settings or press the Reset switch.
%1 malfunction (%2)
Camera type (Canon VB-C300NA | Canon VB-C300PA)
Error (read | write | timeout | ...)
An I/O error for the camera control device has occurred.
If the problem persists, it is a camera failure. Call for service.
%1@%2 %3
Client type (LS/H)
Client host IP address
connected | closed
The HTTP WebView client (LS/H) has started or stopped.
%1@%2 %3 frames / %4 bytes in %5 seconds
Client type (LS/H)
Client host IP address
Number of frames
Number of bytes
Video transmission period
This message indicates the results of video transmission to the client.