Cabling; Protective Earth; Esd Safety Guidelines; Environmental Requirements - Nokia 7368 ISAM CPE A-240Z-A Product Manual

7368 ISAM CPE A-240Z-A Product Guide
2.3.2

Cabling

The following are the guidelines regarding cables used for the CPE equipment:
•
All cables must be approved by the relevant national electrical code.
•
The cables for outdoor installation of CPEs must be suitable for outdoor use.
•
POTS wiring run outside the subscriber premises must comply with the
requirements of local electrical codes. In some markets, the maximum allowed
length of the outside run is 140 feet (43 m). If the outside run is longer, NEC
requires primary protection at both the exit and entry points for the wire.
2.3.3

Protective earth

Earthing and bonding of the CPEs must comply with the requirements of local
electrical codes.

2.4 ESD safety guidelines

The CPE equipment is sensitive to ESD. Operations personnel must observe the
following ESD instructions when they handle the CPE equipment.
During installation and maintenance, service personnel must wear wrist straps to
prevent damage caused by ESD.

2.5 Environmental requirements

See the CPE technical specification documentation for more information about
temperature ranges.
Issue: 01
All manuals and user guides at all-guides.com
This equipment is ESD sensitive. Proper ESD
Caution —
protections should be used when you enter the TELCO Access
portion of the CPE.
3FE-46615-AAAA-TCZZA
ETSI CPE safety guidelines
21