ABB ACS310 Installation Instructions page 2

6a
6. Replace the original terminal cover (6a) with new terminal
cover (6b) (included in the delivery). If using MTAC-01 option
module, remove a detachable part (shown in the picture) from
terminal cover.
10
10. Fasten the hood to drive with two M3×12 screws.
11. Fasten the hood to wall with one M4 screw (not included).
ABB Oy Drives P.O. Box 184 FIN-00381 HELSINKI FINLAND Tel. +358 10 22 11, Fax: +358 10 22 22681, Internet: www.abb.com
6b
7. Install the gland box cover.
8. Fasten the cover with three M4×16 screws.
11 11
12. Drive with MUL1-R4 option installed.
7
9
8
9. Install the hood. First position the front edge carefully, then
press the hood downwards until it snaps on.