Firewall Tab - Inseego 5G MiFi M2000 User Manual

Firewall Tab

The M2000 firewall determines which Internet traffic is allowed to pass between the M2000 and
connected devices and protects your connected devices from malicious incoming traffic from the
Internet. The firewall cannot be turned off. Use the Firewall tab to adjust the general security level of
the firewall, designate a specific device to receive all traffic, and set up specific firewall rules.
VPN Passthrough
To use the VPN Passthrough, ensure the ON/OFF slider is ON. This allows you to establish a VPN
tunnel while using your M2000.
IPv6 Transparent Mode
To use IPv6 Transparent Mode, move the ON/OFF slider to ON. This allows connected devices to be
accessible from the Internet.
DMZ
DMZ allows the connected device specified as the DMZ IP address (Destination IP address) to receive
all traffic that would otherwise be blocked by the firewall.
NOTE:
Allowing DMZ may assist some troublesome network applications to function properly, but the
DMZ device should have its own firewall to protect itself against malicious traffic.
Allow DMZ: Check this box to allow DMZ.
Destination IP address: Enter the IP address of the connected device you wish to become the DMZ
device (the DMZ destination).
Connected Devices screen.
Click Save Changes.
5G MiFi M2000 USER GUIDE
NOTE: You can check the IP address of each connected device on the
69