Controls System Maintenance; Adjusting The Motion-Control Levers; Brake Maintenance - Toro MB TX 2500 Operator's Manual

Controls System
Maintenance
Adjusting the
Motion-Control Levers
If the motion-control levers do not align horizontally,
adjust the right side motion-control lever.
1. Park the machine on a level surface, lower the
hopper, engage the parking brake, shut off the
engine, and remove the key.
2. Push the motion-control levers down out of the
N - position
EUTRAL LOCK
3. Check if the right motion-control lever aligns
horizontally with the left motion-control lever
(Figure 42).
Figure 42
1. Left motion-control lever
2. Right motion-control lever
in the Neutral-lock position
4. To adjust the motion-control levers horizontally,
you must adjust the cam.
5. Release the cushion from the rear of the
machine.
6. Loosen the nut holding the cam
(Figure 42).
g009436
3. Check the horizontal
alignment here
4. Right motion-control lever
(Figure 43).
1. Cam
7. Adjust the cam until it aligns with the left
motion-control lever and tighten the nut for the
cam.
Note:
Moving the cam clockwise (in the vertical
position) lowers the handle; moving the cam
counterclockwise (in the vertical position) raises
the handle.
Important:
Ensure that the flat portion of the
cam does not go above a vertical position
(right or left); otherwise you may damage the
switch.
8. Repeat steps
motion-control lever.

Brake Maintenance

WARNING
If the brakes are not properly adjusted,
serious injury, or death, may occur.
Check your brakes daily. If you encounter any
problems with the brakes while operating the
machine, stop the machine immediately and
bring it to an Authorized Service Dealer for
repair.
Checking the Parking Brake
Service Interval: Before each use or daily
1. Park the machine on a level surface, lower the
hopper, and engage the parking brake.
2. Start the engine and move the throttle lever to
the F position.
AST
3. Move the motion-control levers forward.
Note:
The machine should not move forward.
Note:
If the machine moves forward, refer to
Adjusting the Parking Brake (page
30
Figure 43
2. Nut
2 through 7 for the left
31).
g189389