Changing The Engine Oil And Filter - Toro MB TX 2500 Operator's Manual

Changing the Engine Oil
and Filter
Service Interval: Every 100 hours
Oil Type:: Detergent oil (API service SJ or higher)
Engine Oil Capacity: 1.9 L (2.0 US quarts)
Viscosity: Refer to the table below.
Figure 22
Note:
Dispose of the used oil at a recycling center.
1. Park the machine on a level surface, move
the motion-control levers to the N
position, engage the parking brake, raise the
hopper, and install the cylinder lock.
2. Shut off the engine, and remove the key. Allow
the engine to cool.
3. Start and run engine for a few minutes to warm
the engine oil, then shut off the engine.
4. Change the engine oil as shown in
g017552
5.
6.
-
EUTRAL LOCK
Figure 23.
21
Figure 23
Torque the plug to 13.6 N∙m (10 ft-lb).
Change the engine-oil filter as shown in
24.
Figure 24
g185888
g031623
Figure
g027477