Mitsubishi Electric E1000 Series Service And Maintenance Manual page 36

Hardware
E1151
Follow the steps below to replace the display/display cable of E1151:
1. Power off the operator panel.
2. Follow the instructions under
3. Disconnect the flex cable and the LED cable from the power card. The connec-
tor on the flex cable is a plain connector so just pull the connector out.
4. Remove the two plastic nuts that keep the power card in place.
5. Lift up the power card and gently remove the 4 backlight cables and disconnect
the display cable from the power card.
6. Remove the mounting plate (12 torx screws).
7. Gently lift up the mounting plate and the display.
36
Replacing the Rear Cover to remove the rear cover.
LED cable
plastic nut
display cable
plastic nut
backlight cable
display cable
backlight cable
12 x torx screws
Mitsubishi Electric, MA00758A