Additional Hardware; Memory Card - Mitsubishi Electric E1000 Series Service And Maintenance Manual

Hardware
3.6

Additional Hardware

3.6.1

Memory Card

A Compact Flash memory card can be fitted in E1070, E1100, E1071, E1101 and
E1151 for expansion of the project memory.
Note:
When using an internal Compact Flash memory card, no external Compact Flash memory
card can be used. An external USB Flash drive can be used for the same functions as an
external Compact Flash card.
Compact Flash cards of type I and II are supported by the operator panels. Recom-
mended Compact Flash memory cards are Silicon Systems Silicon Drive and San
Disk Industrial Grade Compact Flash cards.
Installation
Perform the following steps to install an internal Compact Flash card in the operator
panel:
1. Turn off the power to the panel.
Note:
Make sure to use adequate ESD protection.
2. Follow the instructions under Replacing the Rear Cover to remove the rear cover.
3. Flip the back cover; the CPU board is mounted inside the back cover.
4. Insert the Compact Flash memory card in its slot on the CPU board.
memory card slot
5. Re-attach the back cover to the operator panel.
6. Turn on the power to the operator panel.
When the operator panel starts up, you will be asked if you like to move the files to
the internal card; select YES to this question.
22 Mitsubishi Electric, MA00758A