Default Setting - Hitachi ZW 180-6 Operator's Manual

Default Setting

Function
Auto Shut-Down
Rear View Camera Monitor
Aftertreatment Device Regeneration
Inhibit
Shift Change Delay Mode
(Transmission Setting)
Parallel/Tandem Switching Height
Warm Up
f
NOTE: Typical functions are shown in the table. Check the initial values of other functions on each monitor screen.
OPERATOR'S STATION
Item
ON/OFF of auto idling-stop function
Time period for auto shut-down activation
ON (Constant display)
OFF (No display)
AUTO (Display at reverse operation only)
Inhibit regeneration
ON/OFF of travel speed (shift) change delay mode
Height at parallel or tandem circuit operation are
switched
Increases engine speed at engine start to help
warm up in cold environment
1-20
Default
ON
5 min
AUTO
OFF
OFF
Lift arm is level to the
ground
OFF