Hitachi ZW 180-6 Operator's Manual page 240

f
NOTE:
1. When applying lift arm control lever (1) in the "Raise"
position (A), the lever is moved (F) until the lift arm reaches
the position preset by the lift arm kickout. When the lift
arm moves the preset position, lift arm control lever (1)
automatically moves to the Neutral (N) position.
2. When applying bucket control lever (2) in the "Tilt"
position (D) after bucket dump operation, the lever is
moved (G) until the bucket reaches the position preset by
the bucket auto leveler. When the bucket reaches the preset
position, bucket control lever (2) automatically moves to
the Neutral (N) position.
3. When pushing down lift arm control lever (1) to the
"Float" position (C), the lift arm moves to the position preset
by lift arm auto-leveler system and is held in that position.
When the lift arm moves to the preset position, lift arm
control lever (1) automatically moves to the "Neutral" (N)
position. (Machine is equipped with the lift arm auto-leveler
system)
f
NOTE: When operating the machine in Float (C) position,
first hold the lift arm at the float position; then further tilt
the lever to the Float position, and lower the lift arm on the
ground.
OPERATING THE MACHINE
5-2
C
E B
2
N
D A
G F
1
N
MNEC-03-003
M4GB-01-073