Toro ProPass 200 Installation Instructions Manual page 6

1. Hose guide
Note:
Two mounting bolts must be removed
from the chassis rear wall to allow the hydraulic
tank to be mounted. Use the bolts for mounting
the tank.
32. Unpack 4 bolts (3/8 x 1 inch) and nylon locknuts.
Supporting the hydraulic tank from below, pass
the hose guide and hydraulic hoses #3 and #4
through the large central hole in the ProPass
chassis rear wall and locate the hydraulic tank
against the chassis rear wall. Temporarily
clamp, or bolt, the hydraulic tank in place.
Note:
The hose guide should be fed through
the center hole on the front side of the chassis.
Two people may be required
33. Install the hydraulic return hose (#3) and the
hydraulic suction hose (#4) to the appropriate
fittings on the hydraulic tank.
Note:
Hose #3 and hose #4 do not have the
same fittings so each hose will only fit into the
correct fitting in the hydraulic tank.
Note:
When mounting the hoses, make sure
there is adequate clearance to the tires.
34. The hose guide should sit on top of the tab from
the vertical leg of the battery tray
If the holes in the hose guide do not match the
holes in the battery tray tab, the hose guide
length may be adjusted by loosening the bolts
attaching the hose guide to the hydraulic tank
bracket and sliding the hose guide forward or
to the rear as required.
Figure 9
(Figure
g013863
1. Hose guide
35. Attach the hose guide to the battery tray tab
using 2 bolts (1/4 x 3/4 inch) and flange locknuts
(Figure
36. Mount the hydraulic tank to the ProPass chassis
rear wall using the bolt (3/8 x 1 inch), nylon
locknuts and flat washers. Also, use the
mounting bolts previously removed. Tighten the
fasteners.
37. Connect hydraulic hose #3 to the filter outlet
(Figure
10).
1. Filter outlet
38. Connect hydraulic hose #4 to the suction side of
the hydraulic pump
6
Figure 10
10).
11).
Figure 11
2. Hydraulic hose #3
(Figure 12).
g013864
g013865