Toro ProPass 200 Installation Instructions Manual page 4

13. De-burr each hole.
14. Ensure that the ProPass Hitch Tube is clean and
free from dirt or debris.
15. Unpack the engine assembly.
16. Loosen, but do not remove, the 2 bolts and
nuts securing the engine mount brackets to the
engine mounting plate
1. Mounting bolts (2)
17. Remove the two nuts holding the battery hold
down straps in place and set the nuts, washers
and bolt tube off to the side
1. Battery hold down strap
18. Remove the battery from its position on the
assembly and rest the filter on the base plate.
19. Charge the battery; refer to
Charging the Battery (page
20. Since the engine assembly is heavy, positioning
of this component can be difficult. With the help
of an assistant, position the engine assembly
(Figure 3).
Figure 3
(Figure 4).
Figure 4
2. Battery hold down bolt (2)
Activating and
10).
onto the ProPass hitch tube. Ensure that the
engine mount brackets straddle the hitch tube
(Figure 5
plate is approximately 25 mm (1 inch) from the
ProPass hitch tube receiver
1. Hitch tube
g013858
1. One inch
21. Insert the 2 bolts (1/2 x 3 inches) through the
engine mount bracket holes ensuring that a
flat washer is fitted against each outer face of
the engine mount bracket and ensuring that
the bolts pass clear beneath the bottom of the
g013861
ProPass hitch tube. Hand tighten the 2 nuts (1/2
inch) (Figure
4
and that the rear of the engine mount
(Figure
Figure 5
Figure 6
7).
6).
g013911
g013859