Chapter 3 Setup
6.
Device Identification
To identify the device to be maintained among more than one device, ID lamp is used.
The ID lamp is located on the CPU blade installed in the Blade Enclosure.
The ID lamp allows you to identify the device subject to maintenance among more than one CPU blade
installed in the Blade Enclosure.
The ID lamp on CPU blade can also be made blink blue by proper software commands (NEC ESMPRO
Manager) from the management PC on the network. In addition, pressing the ID switch on the CPU blade
brings the ID lamp to light.
You may use the remote control feature of EXPRESSSCOPE Engine 3 (BMC) to perform the same operation
as using the ID switch on the CPU blade.
128
ID switch
DMP
1
RST
2
ID
ID lamp
Express5800/B120d, B110d User's Guide
6. Device Identification