Cases That Require Configuration - NEC Express5800 Series User Manual

Chapter 3 Setup
2.3

Cases that Require Configuration

Only if a case applies to any of following cases, use the SETUP utility to change a parameter which was
configured as factory setting. Other than cases described below, do not change the settings. A list of SETUP
parameters and factory settings are described in Chapter 2 (1. Details of System BIOS) in "Maintenance
Guide".
Category
Basic Change date and time
On/Off NumLock on power ON
On/Off the function to display
the NEC logo during POST
Optional Install RAID Controller board
board
Boot Change the boot order of
devices
Use remote power on function
(from modem)
Use remote power on function
(from RTC alarm)
Control from HW console
terminal
Security Set a password
UPS When the server is supplied
Powerlink with power from UPS, always
turn on the power.
If the server is turned off by
using POWER switch, leave it
OFF even when UPS supplies
power.
Keep the power OFF even
when UPS supplies power.
122
Description
Main
Main
Boot
Boot
Advanced
Slot n Option ROM
Boot
Change the boot priority
Advanced
Configuration
Enabled
Advanced
Configuration
Enabled
Advanced
Configuration
setting.
Security
Enter a password
(Set a password for Administrator first
and then User)
Server
Server
Server
Express5800/B120d, B110d User's Guide
To be changed
System Date
System Time
Bootup Numlock State
Quite Boot Disabled
PCI Configuration PCI
Enabled
Boot Option Priorities
Advanced Chipset
Wake On Ring
Advanced Chipset
Wake On RTC Alarm
Serial Port
Change respective
Administrator Password
AC-LINK Power On
AC-LINK Last State
AC-LINK Stay off
2. Details of System BIOS
Remark
Configurable on OS
Pressing the <Esc> key can
hide the logo.
n is PCI slot number of the
RAID Controller
There are two types of
password; Administrator and
User.
Settings for User password
is limited compared to for
Administrator.