Mitsubishi Electric CP-D70DW Service Manual page 8

BEFORE OPERATION
PRINT PAPER INSTALLATION
Spacers
See the Quick Setup Guide on how to use the spacers.
How to attach the spacers
1. Insert the spacer with the paper flange's stoppers retracted.
2. Turn the spacer until the latches are locked.
When you remove the spacers from the paper flanges, follow the above procedure
in reverse.
Attach the supplied paper flanges to both sides of the print
paper.
When you pinch the latches on the paper flange, the stoppers retract into the shaft.
Attach the flanges to the print paper with the stoppers retracted.
Make sure that the flanges are attached to the print paper securely, and release the
latches.
NOTE
• Take care not to pinch your fingers.
• Do not remove the sticker on the print paper roll yet.
• Do not loosen the paper roll. Any slack in the print paper may degrade the print
quality.
CAUTION
• When placing the print paper, keep the print paper upright.
• When you put the print paper sideways, it may roll and fall. This may cause injury.
NOTE
• Fingerprints or dust on the paper's surface may degrade print quality and cause
paper jams.
BEFORE OPERATION
Press the POWER switch on the rear panel to turn on the
power.
Paper
flange
Spacer
Latch
After the POWER indicator's color has changed from orange to
green, press the OPEN button to release the printing unit out.
Remove the paper strip bin and then pull the knob to open the
door.
Install the print paper into the unit.
Place the printing paper in the correct orientation.
Make sure the paper roll is firmly installed.
Do not push down on the printing unit or the door.
If you push down on the printing unit or the door when they are open, this unit may
fall and it can cause damage or injury.
Load the paper roll slowly into the unit. If it is dropped along the ditches, the unit or
accessories may be damaged.
Sticker
INCORRECT CORRECT
Remove the sticker, insert the print paper between the roller
and guide as shown right, and feed the print paper until the
buzzer sounds.
Remove the sticker before inserting the print paper between roller and guide. Make
sure to insert the paper straight.
Buzzer continues to sound until the printing unit is closed.
•
•
•
•
Close the door.
11
CAUTION
NOTE
NOTE
Keep the rollers clean. Dirt on the rollers may produce poor print quality.
NOTE
When taking the print paper out, pull it up toward you by holding the paper
flanges.
Make sure to turn on the power before replacing the print paper.
Make sure to eliminate any slack from the print paper. If you carry out the
following steps without eliminating the slack, the print paper may be damaged.
POWER switch
OPEN button
Knob
Direction of paper insertion
Print paper
Roller
Guide
Roller
12