Mitsubishi Electric CP-D70DW Service Manual page 11

ERROR MESSAGES AND COUNTERMEASURES
INDICATIONS ON THE FRONT PANEL AND COUNTERMEASURES
If, for some reason, printing is not possible or an error occurs during printing, the indicators on the front panel will
illuminate or blink. In this case, follow the procedure described below.
ALARM PAPER RIBBON POWER
(Orange)
(Green)
(Green)
(Green)
(Green)
(Green)
(Green)
When the ALARM or the PAPER RIBBON indicator illuminates or blinks, open the door and carry out the above
countermeasures.
: Steady on : Off : Blinking
Causes and Countermeasures Page
This printer is in standby mode.
16
Connect a USB cable to the printer when not
connected.
It may take time that the printer is ready to print
images after the image data is sent.
The printing unit is open.
• Close the printing unit.
18
A paper jam or a problem concerning the ink
ribbon occurs.
• Refer to "Overcoming paper jams."
The temperature of the thermal head is too high
or too low.
• Wait until the indication goes off. When the
indicator stops blinking, the printer resumes
printing automatically.
13-14
The ink ribbon which is not available to this
printer is installed.
• Replace the ink ribbon with a new one.
The actual combination of ink ribbon and print
paper is inconsistent with the setting made by the
personal computer.
• Open the printing unit and confirm that the
actual combination of ink ribbon and print
paper is consistent with the setting made by the
personal computer. After checking, close the
printing unit.
11-14
The print paper or ink ribbon is not installed.
The print paper or ink ribbon is used up.
• Install new print paper or ink ribbon.
20
Other errors
ERROR MESSAGES AND COUNTERMEASURES
Press the OPEN button to open the printing unit.
Make sure that the power is turned on before opening the printing unit.
7
Remove the ink cassette.
7
Open the door.
7
Pull out the defective part of the print paper to the direction of
an arrow.
Cut off the defective part of the print paper with scissors.
• Make sure to cut off the printed part of the print paper. Failure to do this may
result in the ink ribbon sticking to the print paper and being torn.
• Make sure to clean the thermal head and the platen roller.
(on pages 21 and 22).
Remove the print paper.
Install the print paper and the ink cassette with the ink ribbon.
(Refer to pages 11-15.)
Close the door.
Close the printing unit by pushing it.
17
OVERCOMING PAPER JAMS
NOTE
Refer to "CLEANING"
18