Mitsubishi Electric MELSEC-Q Series User Manual page 31

"Switch Setting for I/O and Intelligent Function Module" window
Set "Switch 1", "Switch 3", and "Switch 4" as follows.
• "Switch 1": Setting of the number of transmission points ( Page 30, Section 3.1.2 (1))
• "Switch 3": Double check mode setting ( Page 31, Section 3.1.2 (2))
• Switch 4: Waveform output method setting ( Page 33, Section 3.1.2 (3))
• Be sure to set "Switch 1", "Switch 3", and "Switch 4". Furthermore, set the correct and suitable value for the slot
position of the QJ51AW12D2. If the settings are not configured, or if the setting position or the switch selection
value is incorrect, AnyWire DB A20 transmission does not operate normally.
• If the switch settings are changed using the programming tool, write the parameters and then reset the CPU
module or power off and on the system. Without these operations, switch settings are not configured.
CHAPTER 3 OPERATION MODE
29
3