Table of Contents
Advertisement
SPEED LIMITER
The AT125UT ATV is equipped with a vehicle speed limiter adjusting screw. Beginning riders should start with slowest
setting to learn how to control this vehicle. Once the operator has demonstrated mastery of the ATV, the supervising
adult can adjust speed limiter screw to increase the top speed . The vehicle speed limiter keeps the throttle from fully
opening, even when the throttle lever is pushed to the maximum. The adjusting screw may be gradually turned out as the
beginner becomes more familiar with operating this ATV.
NOTICE
SPEED LIMITER ADJUSTMENT
To increase top speed
1.
Loosen locknut (#1).
2.
To increase the top speed of the ATV turn the adjustment screw counter clockwise. (#2).
3.
Tighten the locknut to set adjustment screw in desired position(#1).
To decrease top speed
1.
Loosen locknut (#1).
2.
To decrease the top speed of the ATV turn the adjustment screw clockwise. (#2).
3.
Tighten the locknut to set adjustment screw in desired position(#1).
FRONT BRAKE LEVER
The front brake lever is located on the right handlebar. To apply the front brake, pull the brake lever toward the
handlebar grip.
REAR BRAKE LEVER
The rear brake lever is located on the left handlebar. To apply the rear brake, pull the brake lever toward the
handlebar grip.
The adjustable speed limiter screw must be installed for operation. Failure to install a speed limiter
screw may result in water or dirt ingestion and potential damage to the vehicle.
Adults should always limit maximum restricted
speed within the ability and capacity of the child to
operate the ATV safely. Never allow the child to
adjust the speed limiter screw.
8
1. Locknut
2. Adjustment Screw
3. Adjustment Range
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the AT125UT and is the answer not in the manual?
Questions and answers
i am looking for a reset for the quad one of the saftey wires came off the break i put it on and still no spark
To reset the Coleman Powersports AT125UT after a safety wire came off the brake and there is no spark, follow these steps:
1. Check the safety wire: Reattach the safety wire to the brake properly. Ensure it is securely connected and the brake system is functioning.
2. Inspect the ignition system:
- Check the spark plug for damage, wear, or carbon buildup. Clean or replace it if needed.
- Measure the spark plug gap and adjust it to 0.06–0.085 mm (0.024–0.028 in) if necessary.
- Make sure the spark plug cap, coil wire, and ignition coil are properly connected.
3. Check the engine stop switches:
- Make sure the lanyard cord is properly attached.
- Ensure the wireless key fob is within range and functioning. Replace its battery if needed.
- Confirm the ignition switch is in the ON position.
4. Try starting the engine:
- Set the main switch to ON.
- Make sure the gear shifter is in Neutral.
- Press the start button to crank the engine.
If there is still no spark, inspect all electrical connections and consider checking the fuse (10 Amp) or consulting a technician.
This answer is automatically generated