Do you have a question about the AT125UT and is the answer not in the manual?
Questions and answers
David &Angela King
April 14, 2025
i am looking for a reset for the quad one of the saftey wires came off the break i put it on and still no spark
1 comments:
Mr. Anderson
April 15, 2025
To reset the Coleman Powersports AT125UT after a safety wire came off the brake and there is no spark, follow these steps:
1. Check the safety wire: Reattach the safety wire to the brake properly. Ensure it is securely connected and the brake system is functioning.
2. Inspect the ignition system: - Check the spark plug for damage, wear, or carbon buildup. Clean or replace it if needed. - Measure the spark plug gap and adjust it to 0.06–0.085 mm (0.024–0.028 in) if necessary. - Make sure the spark plug cap, coil wire, and ignition coil are properly connected.
3. Check the engine stop switches: - Make sure the lanyard cord is properly attached. - Ensure the wireless key fob is within range and functioning. Replace its battery if needed. - Confirm the ignition switch is in the ON position.
4. Try starting the engine: - Set the main switch to ON. - Make sure the gear shifter is in Neutral. - Press the start button to crank the engine.
If there is still no spark, inspect all electrical connections and consider checking the fuse (10 Amp) or consulting a technician.
Need help?
Do you have a question about the AT125UT and is the answer not in the manual?
Questions and answers
i am looking for a reset for the quad one of the saftey wires came off the break i put it on and still no spark
To reset the Coleman Powersports AT125UT after a safety wire came off the brake and there is no spark, follow these steps:
1. Check the safety wire: Reattach the safety wire to the brake properly. Ensure it is securely connected and the brake system is functioning.
2. Inspect the ignition system:
- Check the spark plug for damage, wear, or carbon buildup. Clean or replace it if needed.
- Measure the spark plug gap and adjust it to 0.06–0.085 mm (0.024–0.028 in) if necessary.
- Make sure the spark plug cap, coil wire, and ignition coil are properly connected.
3. Check the engine stop switches:
- Make sure the lanyard cord is properly attached.
- Ensure the wireless key fob is within range and functioning. Replace its battery if needed.
- Confirm the ignition switch is in the ON position.
4. Try starting the engine:
- Set the main switch to ON.
- Make sure the gear shifter is in Neutral.
- Press the start button to crank the engine.
If there is still no spark, inspect all electrical connections and consider checking the fuse (10 Amp) or consulting a technician.
This answer is automatically generated