Toro 140-2054 Installation Instructions

Sunshade Kit
for TimeCutter
Model No. 140-2054
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Support the rear of the machine with jack stands
and remove the rear tires.
4. Secure the receiver brackets to the front 2 holes
in the frame using 2 bolts (1/2 inch x 1-1/8
inch) and split lockwashers
machine is not equipped with a ROPS, insert the
spacer plate as shown in
Important:
Ensure that you do not pinch
any cables or fuel lines when installing the
receiver bracket.
1. Bolt (1/2 inch x 1-1/8 inch)
2. Split lockwasher (1/2 inch)
3. Frame
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
® Riding Mowers
ARK
(Figure 1). If your
Figure 1.
Figure 1
4. Spacer plate (optional)
5. Receiver bracket
Register at www.Toro.com.
5. Loosely secure the outer holes of the front bow
to the second holes of the rear bow using 2 bolts
(1/4 x 5/8 inch) and locknuts
Note:
Ensure that the ends of the front bow are
on the outside of the rear bow.
1. Bolt (1/4 x 5/8 inch)
2. Locknut
3. Rear bow
6. Loosely secure the top bow to the front and rear
bow using 2 bolts (1/4 x 5/8 inch) and locknuts
(Figure 2).
7. Angle the top bow approximately 10 cm (4
inches) forward of vertical and tighten the
fasteners.
8. Loosely secure the braces to the posts using 2
bolts (1/4 x 1-1/4 inches), washers, and locknuts
(Figure 3).
g309688
Original Instructions (EN)
Form No. 3436-462 Rev B
Installation Instructions
(Figure
Figure 2
4. Top bow
5. Front bow
All Rights Reserved *3436-462* B
Printed in the USA
2).
g309689