Toro 140-5036 Installation Instructions

Vac bagger blower cover for titan zero-turn-radius riding mower

Download this manual

HD Vac Bagger Blower Cover

TITAN

Model No. 140-5036

Safety

Safety and Instructional Decals

Safety decals and instructions are easily visible to the operator and are located near any area

of potential danger. Replace any decal that is damaged or missing.

1. Warning—read the Operator's Manual.

2. Warning—hearing protection must be worn.

3. Thrown object hazard—do not operate the blower without the

entire system installed and latched.

8111 Lyndale Avenue South

Bloomington, MN 55420

Zero-Turn-Radius Riding Mower

136-4164

4. Cutting/dismemberment hazard, impeller—keep away from

moving parts; keep all guards and covers in place.

5. Cutting/dismemberment hazard, impeller—disengage the

PTO, remove the key, and wait for all moving parts to stop.

6. Warning; loss of traction—do not operate with only

counterbalance weights installed; do not operate with only

E-Z Vac installed; operate only with both E-Z Vac and

counterbalance weights installed.

Original Instructions (EN)

Printed in the USA

Form No. 3439-702 Rev A

Installation Instructions

decal136-4164

Page 1 Form No. 3439-702 Rev A HD Vac Bagger Blower Cover TITAN ® Zero-Turn-Radius Riding Mower Model No. 140-5036 Installation Instructions Safety Safety and Instructional Decals Safety decals and instructions are easily visible to the operator and are located near any area of potential danger.
Page 2 Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. – No parts required Remove the existing cover. Cover Hex-head bolt (1/4 x 5/8 inch) Install the new cover.
Page 3 Removing the Existing Cover No Parts Required Procedure Remove the existing 5 shoulder screws, 5 Phillips-head screws, blower guard, and cover from the blower assembly (Figure Note: You can discard these parts. g321826 Figure 1 4. Blower assembly 1. Shoulder screw 2.
Page 4 Secure the cover to the blower assembly using the 11 hex-head bolts (1/4 x 5/8 inch) and 1 locknut (1/4 inch) as shown in Figure Installing the New Cover Parts needed for this procedure: Cover Hex-head bolt (1/4 x 5/8 inch) Locknut (1/4 inch) Procedure Align the new cover with the holes on the blower...