Ubiquiti NanoBeam M5 Setup

1. Purchase the Ubiquity NanoBeam M5 bridge here on Amazon:
2. To access the Nanobeam web interface, your computer must be in the same subnet range as the unit.
3. Click Start, and type Control in the search field, then select Control Panel.
4. Click on Network and Internet.
5. Click on Network and Sharing Center.
6. On the left pane, click the Change adapter settings link.
7. Right-click on your computer's Ethernet network adapter and select Properties.
8. Select the Internet Protocol Version 4 (TCP/IPv4) option.
9. Click the Properties button.
10. Select the Use the following IP address option.
11. Set the IP address to
12. Set the Subnet mask. (e.g., 255.255.0.0).
13. Click OK.
14. Click Close again to close the network adapter properties.
15. Connect the truck scale intercom to a POE switch, plug a computer into the POE. Connect the first bridge device
to the POE injector that came with it. Plug the LAN port of that POE injector into the POE Ethernet switch (can
use a non-powered port). Do NOT plug the wireless bridge directly into the same POE Switch as the intercom
since they use different voltages.
1

Ubiquity NanoBeam M5 Setup for Truck Scales

192.168.1.1 .
Nanobeam M5 bridge