Section 3 - Installation (ATSC EC702HP Transmitter)
Connection between combiner and rejection load
STEP 1
Locate the combiner cable with the identification LOAD 1B.
Carefully connect each cable in its respective connector in the rejection loads drawer. After
make the tightening with wrench 1 1/4".
STEP 2
Connect the DC power supply cable in the rejection loads drawer.
Manual Rev. 0.0 - April 2016
LOAD 1B
LOAD 1B
Figure 3-47 - Connection combiner and loads drawer
Figure 3-48 - DC connector of the loads drawer
CONECTOR DC DA
DC CONNECTOR OF
GAVETA DE CARGA
THE LOADS DRAWER
SOMADOR 2:1
COMBINER 2:1
MOD COM 2:1 C-HC-40C
GAVETA DE CARGAS
LOADS DRAWER
– MOD GV 40041
CABO LOAD 1B
LOAD 1B CABLE
3-36