Sealey LED01 Series Instruction Manual

thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. safetY
1.1. general
It is important to ensure that the lamp is fully charged before initial use.
9
dO nOt turn the lamp on when it is being charged.
8
dO nOt shine directly into your, another person's or an animal's eyes.
8
dO nOt allow children to use the lamp.
8
dO nOt leave battery in a discharged state. Recharge battery immediately.
8
Recharge the battery at least once every six months of non-use.
There are no user serviceable components. dO nOt dismantle.
9
dO nOt pull the charger plug from the mains socket by the lead.
8
1.2. BatterY safetY
Warning! To reduce the risk of burns or fire:
‰
dO nOt Attempt to open, disassemble, modify or service the battery pack.
8
dO nOt Crush, puncture, short external contacts or dispose of in fire or water.
8
dO nOt expose to temperatures above 60°C (140°F).
8
Recycle or dispose of used battery as stipulated by local regulation.
9
If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in your eyes, rinse thoroughly with cool
9
water and seek immediate medical attention
2. intrOduCtiOn
Slimline pocket lamp for use in confined spaces. Inspection arm can be folded 180º for hands-free use. Super bright COB and SMD LED, 6000-
7000k, 80+CRI. High impact plastic housing with aluminium light and a strong magnet on the bottom. Rechargeable high quality 3.7V 700Ah
Li-ion battery with a charging time of 2.5 hours. Supplied with USB charging cable.
3. speCifiCatiOn
model no .......................................................... led01 Series
Battery ....................................................3.7V 700mAh Li-ion
led Quantity ................................................ 2 COB + 1 SMD
lumen output:
Top spotlight .................................................................. 80lm,
Front (High/Low) ................................................200lm/100lm
Rear ............................................................................. 180lm
operating time:
Top spotlight ......................................................................3hr
Front .....................................................................3.5hr/1.5hr
Rear ..................................................................................2hr
Charging time: ................................................................2.5hr
length:
Folded .........................................................165 x 20 x 28mm
extended .....................................................300 x 20 x 28mm
4. Charging
4.1. The battery fitted to this lamp is considered to be a consumable item and its ability to accept charge will reduce over time. We will
warranty it against mechanical and electrical defect for a period of one year, this does not cover fair wear and tear. If the battery is not
properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the
battery even if it is less than one year old.
4.2. Connect the charger into the charge port on the lamp, see fig.1. Plug into power supply and turn on, the green charge indicator led on
the lamp will flash as the battery charges. When fully charged the led turns to continuous green.
4.3. Charge the battery for 4-5 hours for its initial charge. normal charge time is approx 2.5hrs. disconnect from mains supply.
© Jack Sealey limited
2 COB + 1 reChargeaBle slim fOlding
pOCket light
led01 series
model no:
Original Language Version lED01 Series| Issue1 17/09/19