Remocon RMC CHML Series Instruction Manual

Instruction Manual of RMC-xxxCHML series
◎COPY FACE-TO-FACE(Self-learning)
Assume RMC-xxxCHML is remote A and the original remote you want to copy is remote B.
When you copy, keep the distance of 2 remotes for around 10CM.

Copy Rolling(Hopping) code remotes(without Seed code)

Step 1.
Keep pressing the 2nd & 3rd buttons of remote A simultaneously for around 2 sec.; When the Red light
starts to flash every 0.5 sec., it enters duplicating mode and you can release the buttons now.(If you do not
press any button or the reading is failure, it will stop flashing after 25 sec.)
Step 2.
(For common frequencies: 434MHz, 868MHz, 370MHz & 315MHz) Suggest to press the first button of
remote B within 4 sec. and keep pressing it;
(For other frequencies-REMARK 1) Suggest to press the first button of remote B after 4 sec. and keep
pressing it.
Step 3.(Only needed when copy remotes with HCS format)
When the Red light of remote A keep lightening(the light goes strong and weak alternately), please release
the button of remote B and then press the same button again; the Red light of remote A may stop and
keep lightening for several sec.(sometimes it will take longer time to scan the codes of remotes with HCS
format).
Step 4.
When the LED of remote A turns green light, press the button of remote A that you would like to store
within 5 sec.; the light will turn orange and then keep flashing Red light(ready to read next button).
Step 5.
Within 12 sec., press next button of remote B and then repeat Step. 4.
Step 6.
Repeat Step 5. until you finish the duplication of all buttons of remote B.
Step 7.
Wait 12 sec. until the Red light of remote A stop flashing(or reload the battery) to finish the duplication
procedure. The LED light will be Orange under Rolling code transmitting mode.

Copy Rolling(Hopping) code remotes with "Seed Code(s)"

1