Cub Cadet Z-Force S Operator's Manual page 7

Figure 2-8
15. Remove the click pins and slide the rod out of the brace
bracket assembly (#3). Be sure not to lose the flange
bearings when removing the rod. See Figure 2-9.
Figure 2-9
16. Lift the back end of the brace assembly and line the holes
up with the holes in the mounting brackets (#8). Then
slide the rod through the mounting brackets (#8), flange
bearings and the brace bracket assembly (#3). When in
place in, re-install the click pins in the rod to secure it in
place. See Figure 2-9.
17. Z-Force S ONLY: Lift the front of the brace bracket
assembly (#3) up and line the holes of the brace bracket
assembly and the deck hanger brackets. Using the washers
saved from step 5, hex washer screws (#25), lock washers
(#26), flat washers (#28) secure the brace bracket assembly
(#3) to the deck hanger brackets. See to Figure 2-10.
Figure 2-10
18. PRO 100 ONLY: Lift the front of the brace bracket assembly
(#3) up and line the holes on the brace bracket assembly (#3)
and the deck hanger brackets. Use hex screws (#25), lock
washers (#26), and shoulder spacers (#29) to secure the brace
bracket assembly (#3) to the deck hanger brackets. See to
Figure 2-11.
Figure 2-11
NOTE: If pivot pins do not align with the deck hanger
brackets, loosen the hex screws in Step 11 (Figure 2-6) to
install pins and then tighten.
19. Install and tighten the floor board hardware.
S
ection
2 — A & S -U
SSembly et p
7