Cub Cadet Z-Force S Operator's Manual page 6

8. Remove the seven smaller screws and two larger screws on
the front of the floor board. See Figure 2-4.
9. Slide the floor board up the steering wheel column and out
of the way.
10. With the floor board out of the way, remove the hex
screws, flat washers and flange lock nuts on each side of
the front axle. See Figure 2-5.
11. Using two hex screws (#9), spacers (#19), flange lock nuts
(#13) from the hardware pack and the existing flat washers
from Step 10, install the mounting brackets (#8) on each
side of the front axle. See Figure 2-6.
6 S 2— A
ection SSembly
Figure 2-4
Figure 2-5
& S -U
et p
Figure 2-6
12. Slide the floor board down into position, but do not install
hardware yet.
13. On the right side of the tractor mount the handle mount
bracket (#7) to the frame with a hex washer screw (#10) and
spacer (#23) as shown in Figure 2-7.
Figure 2-7
14. Secure the handle mount bracket (#7) to the mount bracket
(#8) using a hex screw (#12) and flange lock nut (#13). See
Figure 2-8.