Setting Measurement Condition (2/4) (Ua-200A); Filter - Topcon UA-10 Series Instruction Manual

3.7 Setting Measurement Condition (2/4)
(UA-200A)

3.7.1 Filter

Selects a type of a combination of Tristimulus filter in order to measure Luminance or
chromaticity. And you can select one filter from Tristimulus filter X, Y, Z. To set the filter, go
through the following steps.
1
Open the [Recipe] dialog, and select [Measurement Conditions (2/4)].
2 Select one filter from [Filer] pull down menu.
Select one setting from [Luminance/Chromaticity], [Luminance], and [User specified].
Memo
In [Luminance/Chromaticity] and [Luminance], Tristimulus filter X, Y, Z cannot
change.
3
When you select the [User specified] from [Filter] pull down menu, check box of X, Y, Z
filter become available. Only filter checked in the check box is enable.
Memo
In [User specified], one or two filter are selectable. You canot remove all check
box.
82