Miele E 429/1 Fitting Instructions

Fitting the adapter for the water feed for E 429/1
Miele Company Ltd., Fairacres, Marcham Road, Abingdon, Oxon, OX14 1TW, Tel 0845 365 0555, Fax 0845 365 0777,
Internet: http://www.miele.co.uk / !
Alteration rights reserved / Publication date 23.02.2012
The bottom spray arm in the washer-disinfector has to be
replaced by a special adapter in order to supply water to the
mobile injector unit.
To do this:
^ Loosen thumb nut A in the middle of the spray arm.
^ Then take spray arm B off.
^ Unscrew spigot nut together with the spray arm spindle C
from feed pipe D.
^ Screw the adapter onto the feed pipe.
The adapter is sprung and must connect correctly with the
water feed on the injector unit when it is pushed into the
cabinet. It needs to be set 4 to 5 mm higher than the water feed
on the mobile injector unit.
To align the height of the adapter:
^ Loosen the upper part of the adapter.
^ Then push the adapter upwards or downwards to set the
height.
^ Then tighten up the upper part of the adapter.
,
The adapter should be checked on a regular basis to
make sure it is correctly set.
en
M.-Nr. 09 337 930 / 00