Operation Of Remote Control Unit - Kenwood NV-500 Instruction Manual

Operation of remote control unit

12
Loading batteries
1 Remove the cover.
Operation
After plugging the power cord of this unit, press
the key of the remote control unit to turn the
system ON. When the system is turned ON, press
the key of the function to be operated.
When the remote control unit is attached to the
main unit, the power can be switched ON/OFF
only using the POWER (
÷ When pressing more than one remote control keys
successively, press the keys securely by leaving an
interval of 1 second or more between keys.
To light the back light:
(The back light is permanently on when the remote control unit is
attached to the main unit with power on.)
Press and hold the CLOCK/LIGHT key for
about 2 seconds.
When the remote control unit is detached from
the main unit, it is recommended to leave the
display back light off in normal condition in
order to save the battery power.
1.The provided batteries are intended for use in operation checking, and their service life may be short.
2.When the batteries are nearly exhausted, "Low Battery" appears and the remote controllable distance decreases.
Notes Notes Notes
In this case, replace all of the 6 batteries with new ones. (It is recommended to replace batteries with alkaline
batteries.)
3.If direct sunlight or the light of a high- frequency fluorescent lamp (inverter type, etc.) is incident to the remote
sensor, malfunction may occur. In such a case, change the installation position to avoid malfunction.
Attaching/detaching the remote control unit
1 Open the terminal block
cover of the main unit.
Terminal block cover
÷ Do not touch the terminals.
2 Insert batteries.
÷ Insert six R6 ("AA"-size) batteries
following the polarity indications.
) key on the main unit.
CLOCK
/LIGHT
2 To attach the remote control
unit to the main unit:
Attach by slightly
tilting the remote
control unit.
3 Close the cover.
Operating range
(approx.)
Remote sensor
6 m
Model : GRC-NV501 (for U.S.A. and Canada)
Model : GRC-NV502 (for Europe and U.K.)
Model : GRC-NV503 (for other countries)
Infrared ray system
3 To detach the remote control unit
from the main unit:
Remove in the
upper direction by
slightly tilting the
remote control unit.
÷ Be sure to close the cover when
the remote control unit is detached.
To reset the remote control unit
The remote control unit may mal-
function due to strong external noise,
etc. In this case, remove all batter-
ies and push the reset button with a
thin-tipped object. This resets the mi-
crocomputer to the initial condition.
Reset button
Remote control
signal transmitter
6 m