Special Features; In Regard To Demonstration; Accessories - Kenwood NV-500 Instruction Manual

6

Special features

Bidirectional remote control unit with play mode display at hand
The bidirectional remote uses a large-sized display for easy-to-see, simple operations.
Dolby Virtual Surround
The Dolby Virtual Surround function provides realistic surround effect through only two
loudspeakers.
High output power with large headroom
High, 100 W + 100 W power amplifier enables powerful musical reproduction. (NV-500)

In regard to demonstration

This unit is equipped with a demonstra-
tion function (only display). The demon-
stration consists of sequential change of
display and indicators showing the op-
erations, but the audio itself does not
change. The demonstration function can
be cancelled as follows.
Leave the remote control unit attached to
the main unit during operation.
÷ The setting is remembered even when the power is switched off.
÷ This operates automatically when a power failure has occurred or the plug of the power cable has been pulled while
the power was ON. Cancellation is possible by pressing the key during the demonstration.
Unpacking
Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately.
If your unit was shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company
receiving the unit) can file a claim against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Keep this manual handy for future reference.

Accessories

FM indoor antenna (1)
Batteries (R6/AA) (6)
@
Please confirm that the following accessories are present.
To switch over the demonstration:
Switch power ON before the following
operation.
CONFIRM
To cancel the demonstration mode:
/DEMO
To start the demonstration mode:
Loop antenna (1)
*AC plug adaptor (1)
Before applying power
Press the CONFIRM/DEMO key.
Press and hold the CONFIRM/
DEMO key for about 2 seconds.
Remote control unit (1)
*Use to adapt the plug on the power
cord to the shape of the wall outlet.
(Accessory only for regions where
use is necessary.)