Samsung iDCS 500 Manual page 5

3-4 Chapter 3
Installing Printed Circuit Cards
Switches 1 through 4 select the country the system is installed in.
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Switch 5 select whether APD enable or not.
APD(Auto Program Download) :
When it is set to "ON" and the version of SMARTMEDIA is not match to current system version,
system S/W will be replaced to the S/W of SMARTMEDIA.
These DIP switches will not take effect unless the switches are set in the wanted position and the
system memory is cleared manually by using the Memory Backup switch.
Install the SmartMedia card. Install daughter board(s). Set the MCP DIP switches on the card to the
desired positions.
Insert MCP card in the CAB slot labeled MCP/LCP
of the card to ensure that it is fully inserted into the back plane connector. To prevent accidental
damage to the MCP card, the MCP/LCP connector on the back plane is positioned to mate only with
the MCP or LCP card. Other interface cards will not mate with this connector and the MCP card will
not mate with any other connector.
NOTE: Do not insert this card with system power ON.
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
Figure 3-2 MCP Location
1 Country
OFF Korea
ON USA
OFF UK
ON Italy
OFF Australia
ON New Zealand
OFF Holland
ON Denmark
. Push firmly at the top and bottom
(see Figure 3-2)
M
C
P