Related Manuals for Toro 22420
Summary of Contents for Toro 22420
- Page 1 Form No. 3395-220 Rev B Bore Drive Head Attachment Compact Utility Loader Model No. 22420—Serial No. 315000001 and Up g029193 *3395-220* B Register at www.Toro.com. Original Instructions (EN)
- Page 2 Introduction Model No. The machine is a hydraulically powered auger attachment for Toro compact utility loaders. It is designed to dig vertical holes in earth for the installation of posts, plants, and other Serial No. construction and landscaping needs. It is not intended to drill holes in pavement, concrete, or ice.
-
Page 3: Table Of Contents
Removing an Accessory ........... 6 Boring a Hole ............6 To ensure optimum performance and continued safety Boring the Hole ............6 certification of the machine, use only genuine Toro Reaming the Hole............ 7 replacement parts and accessories. Replacement parts Storage ................. 8 and accessories made by other manufacturers could Troubleshooting ............ -
Page 4: Stability Ratings
WARNING CAUTION When going up or down hill, the machine could Hydraulic couplers, hydraulic lines/valves, and overturn if the heavy end is toward the downhill hydraulic fluid may be hot and can burn you if you side. Someone may be pinned or seriously injured touch them. -
Page 5: Safety And Instructional Decals
To best protect your investment and maintain optimal performance of your Toro equipment, count on Toro genuine parts. When it comes to reliability, Toro delivers replacement parts designed to the exact engineering specification of our equipment. For peace of mind, insist on Toro genuine parts. -
Page 6: Operation
(Figure the attachment. Installing Accessories Toro offers several different rods and bits for use with the attachment. Purchase accessories from your Toro dealer. 1. Stop the engine, wait for all moving parts to stop, and remove the key. -
Page 7: Reaming The Hole
5. With the person guiding the boring bit positioned to the right of the trench (Figure 5), start the engine, move the pump selector valve to slow (turtle) (200 and 300 series traction units only), position the throttle to within the middle of the rpm range, and pull the auxiliary hydraulics lever rearward to start the forward rotation of the boring bit. -
Page 8: Storage
Storage 1. Before long term storage, wash the attachment with mild detergent and water to remove dirt and grime. 2. Check the condition of the hydraulic hoses. Replace any damaged hoses. 3. Ensure that all hydraulic couplers are connected together to prevent contamination of the hydraulic system. -
Page 9: Troubleshooting
Troubleshooting Problem Possible Cause Corrective Action The bore drive head does not rotate. The hydraulic coupler is not completely Check and tighten all couplers. connected A hydraulic coupler is damaged. Check the couplers and replace any that are damaged. There is an obstruction in a hydraulic hose. Find and remove the obstruction. - Page 10 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 11 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 12 If for any reason you are dissatisfied with your Underground Dealer’s service or have difficulty obtaining guarantee information, contact the Toro importer. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.