Epson LightScene EV-110 User Manual page 130

Depending on the signals from the sensors, you can execute one of the following projector operations
that you have already selected in the projector's menu:
• Power On/Power Off
• Execute A/V Mute/Release A/V Mute
• Start Playlist/Stop Playlist
• Source Select
• Light Source Mode: Normal/Light Source Mode: Quiet
See the EV-115/EV-110 External Sensors Setup Guide for details.
Caution: Incorrect connection could damage the product. Contact a qualified technician to connect the
external sensor device.
Note: Up to two sensors are available at the same time. You can also select settings for a combination
of two signals. You need to process the sensor cable so that you can connect it to the DC Out
(2.0A)/GPI In port. Or, you can use a commercially available connector instead. You can also connect
other external devices such as buttons and switches.
1. Connect external sensors to the DC Out (2.0A)/GPI In port.
2. Press the Menu button on the remote control, select the Extended menu, and press
3. Select DC Out (2.0A)/GPI In and press
4. Select Always On/On as the DC Out/GPI In setting.
5. Select GPI-1 Settings.
6. Select the Low -> High setting, and then select one of the following operations to be executed when
the sensor signal exceeds a certain voltage:
• Power On/Power Off to turn the projector on or off.
• Execute A/V Mute/Release A/V Mute to enable or disable A/V Mute.
• Start Playlist/Stop Playlist to start or stop playing your playlist from Favorite Playlists. You also
need to select the target playlist in the Favorite Playlists setting.
• Source Select to switch the image source. You also need to select the target source in the
Source setting.
• Light Source Mode: Normal/Light Source Mode: Quiet to switch the Light Source Mode
setting.
Enter.
130
Enter.