Troubleshooting - Culligan BAEMUV1SHSK SSA User Manual

TROUBLESHOOTING (BOTTLE)
PROBLEM
Water does
not dispense.
Cold water does
not dispense.
Hot water does
not dispense.
Dispenser is noisy
during operation.
Water leaks from the
water dispense point.
Water is dripping out
of the dispenser and
onto the floor.
The water being
dispensed has
a strange taste.
POSSIBLE CAUSE
Dispenser is unplugged.
Main power supply is off.
The lower cabinet door is open.
The water bottle is empty.
The connection between the water
bottle cap and the water bottle
cap connector is not secure.
System has malfunctioned.
Cooling system switch is OFF.
Too much cold water consumed
in a short period of time.
The ventilation around the
dispenser is insufficient.
System has malfunctioned.
Hot water switch is OFF.
Too much hot water has been
consumed in short period of time.
System has malfunctioned.
The dispenser is not level.
Dispenser is touching other objects.
The buttons are stuck down.
The water dispense point
has been damaged.
The hot tank drain cap is
not fastened properly.
The connection between the water
bottle cap and the water bottle
cap connector is not secure.
The hot or cold water tank is leaking.
This is not uncommon
with new dispensers.
Dispenser requires cleaning.
Plug the dispenser into a grounded
Re-establish main power supply.
Remove water bottle and unplug
Wait 15 minutes for the water to cool.
Provide at least 6 in (15 cm) of clearance
Remove water bottle and unplug
Wait 15 minutes for the water to heat.
Remove water bottle and unplug
Place the dispenser on a level, flat surface.
Move dispenser away from other objects.
Check for foreign objects in the button area.
Contact Culligan Customer Service.
If the seal inside the drain cap is torn
or damaged then replace with a new one.
Remove water bottle and unplug
The taste usually goes away after
Clean the siphon tube and waterways.
(See CLEANING AND MAINTENANCE)
12
SUGGESTION
GFCI power outlet.
Close door and allow time for
pump to fill the reservoirs.
Replace water bottle.
(See INITIAL SETUP)
Properly secure connection.
the dispenser. Contact dealer.
Turn cooling switch ON.
on all sides of the dispenser.
the dispenser. Contact dealer.
Turn hot water switch ON.
the dispenser. Contact dealer.
844-787-3148
Tighten the drain cap.
Properly secure connection.
the dispenser. Contact dealer.
the first bottle has been used.