Page 1
RELEASED 13/Feb/2019 14:38:46 GMT 22204911 Revision E February 2019 Reciprocating Air Compressors Engine Driven Wheelbarrow SS3, SS5 Owner’s Manual with Parts List Owner’s Manual with Parts List Manuel du propriétaire avec liste des pièces Manual del propietario con la lista de piezas...
RELEASED 13/Feb/2019 14:38:46 GMT CONSUMER INFORMATION SHEET Thank you for purchasing an Ingersoll Rand product. We trust that it will offer you many years of trouble-free service. If you encounter any problems or need assistance, please refer to the information provided in this sheet. ...
RELEASED 13/Feb/2019 14:38:46 GMT ABOUT THIS MANUAL This manual provides safe and reliable instructions for the installation, operation and maintenance of your Ingersoll Rand air compressor. Carefully read this manual before attempting to operate or perform any maintenance. If you are uncertain about any of the instructions or procedures provided in this manual, contact Ingersoll Rand.
RELEASED 13/Feb/2019 14:38:46 GMT SAFETY INFORMATION ADDITIONAL GENERAL SAFETY PRECAUTIONS Do not point air nozzles toward anyone. • Compressor must be operated in well-ventilated area. Do not touch the compressor pump, engine or discharge • • tubing during or shortly after operation. These parts Do not directly inhale compressed air.
RELEASED 13/Feb/2019 14:38:46 GMT INSTALLATION SELECTING A LOCATION INSTALLING THE INLET AIR FILTER GENERAL CAUTION Select a clean, dry, well-lighted area with plenty of ventilation Do not operate without air inlet filter proper cooling air flow and accessability. Locate the unit atleast 12 inches (30 cm) from walls.
RELEASED 13/Feb/2019 14:38:46 GMT INSTALLATION Temperature Viscosity @ 100°F Viscosity Around (378°C) Grade Compressor °F °C Centistokes < 40 < 4.4 40-80 4.4-26.7 80-125 26.7-51.0 If you use a petroleum-based compressor lubricant at start- up and decide to convert to All Season Select later on, the pump must be decarbonized and flushed before conversion.
Note: SS3 Crankcase capacity is one (1) pint (0.5 liters) Note: SS5 Crankcase capacity is one (2.1) pints (1 liters) Replace the oil fill plug HAND TIGHT ONLY.
RELEASED 13/Feb/2019 14:38:46 GMT OPERATION GENERAL NOTICE The air compressor is designed for 100% continious duty When the tank reaches cut-out pressure, the operation with the use of Ingersoll Rand synthetic lubricant compressor stops pumping but the engine continues and 60% continious duty operation with the use of petroleum to run When the reciever tank pressure drops below lubricant.
RELEASED 13/Feb/2019 14:38:46 GMT MAINTENANCE FILTER REPLACEMENT (SS3) WARNING Unscrew and remove the wing-nut (A). Disconnect wire from engine spark plug and release air pressure from the tank before performing Remove the filter cover (B), baffle (C) and element (D) from the base (E).
RELEASED 13/Feb/2019 14:38:46 GMT MAINTENANCE COMPRESSOR PUMP OIL CHANGE 2. At the center of the span, perpendicular to the belt, apply pressure to the outer surface of the belt with a Remove the oil drain plug (A) and allow the lubricant to tension gauge.
RELEASED 13/Feb/2019 14:38:46 GMT TROUBLESHOOTING This section provides a list of the more frequently encountered malfunctions, their causes and corrective actions. Some corrective actions can be performed by the operator or maintenance personnel, and others may require the assistance of a qualified Ingersoll Rand technician or your dealer.
RELEASED 13/Feb/2019 14:38:46 GMT SS5 COMPRESSOR PARTS LIST EN-20 22204911 Rev. E...
Page 21
RELEASED 13/Feb/2019 14:38:46 GMT SS5 COMPRESSOR PARTS LIST Item DESCRIPTION Qty Item DESCRIPTION Qty 97334148 BARE, SS5 47626840001 BELT 24205064 SCREW TUBE, PUMP TO 47627666001 UNLOADER SS5 WHEEL 95750394 WASHER BARROW 32170946 FILTER TUBE, CONNECTION FOR 47627667001 FLOATING WB 47625510001 RECEIVER 95943213 CONNECTOR...
Page 22
KITS & ACCESSORIES START-UP KIT CRANKCASE HEATER KIT Each start-up kit contains one (1) bottle of Ingersoll-Rand Crankcase heaters are recommended when ambient Contractor Series Synthetic Lubricant, one (1) air filter temperatures are consistently below 32° F (0°C). An easy-...
RELEASED 13/Feb/2019 14:38:46 GMT WARRANTY AND LIMITATION OF LIABILITY WARRANTY Ingersoll Rand company warrants that the equipment manufactured by it and delivered hereunder shall be free of defects in material and workmanship for a period of twelve (12) months from the date of placing the equipment in operation or eighteen (18) months from the date of shipment, whichever shall occur first.
Need help?
Do you have a question about the SS3 and is the answer not in the manual?
Questions and answers