Table of Contents
Advertisement
4.2.10 Profibus Protocol communication set-up
The configuration and parameterization of the EntelliPro ES is to be performed with the fielbus configurator of the bus
master. Following the configuration and parameterization with the 'SyCon' configuration tool for CIF communication
cards (Hilscher) is described as an example.
The following steps must be systematically taken for proper installation:
Installation of the SyCon on a PC. A licensed version must be available.
Installation of a Profibus communication component
A Pentium II with 64MB RAM is a prerequisite.
For a Master- slave configuration, a master is defined, which must fit to the Profibus component to be installed. The
slaves are inserted to suit the EntelliPro ES installed in the switch board and fitted with an address. During insertion
of the EntelliPro ES the GSD file will be loaded automatically.
EP OS MOTOR MANAGEMENT SYSTEM – INSTRUCTION MANUAL
CHAPTER 4: COMMUNICATION
Right-hand mouse key
for the configuration or
parameterization
4.50
Advertisement
Table of Contents
