Mitsubishi Electric Jet Towel JT-MC206GS-W-E Installation Manual page 9

Installation method - continuation
1. Place the power cable through the
cord bushing and reattach it to the
circuit case with the terminal block
cover mounting screw.
6
2. Check that the power cable and wires
are not pinched anywhere.
1. Insert the tabs (2 locations) of the
main unit panel into the locks of the
base hooks and fi x it with screw (1).
The screw is inside the front cover.
2. Check that the 2 hooks on the main
unit panel are hooked in the base.
3. Gently press the unit against the wall,
and fi x it in place using 2 accessory
mounting screws (5×30).
When installing on a concrete wall, use
commercially available metal screw plugs with
7 the procedures below before fixing the front
cover onto the base.
① Temporarily place the main panel on the
base.
② Mark the position of the hole in the wall
through the mounting screw hole with a
pen.
③ Remove the main unit panel and insert
commercially available metal screw plugs
into the marked locations of the wall.
Reinforce any walls made with materials other
than concrete before installation.
1. Open the front cover and attach the air fi lter.
2. Close the front cover and push the tab into
latch the front cover shut.
3. Check that the front cover is securely closed.
Check to see that the front cover is fitted
Caution
securely.
Press against the front cover so that it is
firmly closed against the main panel.
8
※ Refer to "How to open/close the front
Gap
① Close the right side
4. Attach the drain tank.
cover" (Page 11).
② Close the left side
(both the upper and lower parts)
Base
Circuit case
Main unit panel
Tab
Base
Base
Main unit panel
Plug positioning
Mounting screws
Mark the wall in
(5×30)
2 places
(Accessories)
Front cover
Drain tank
− 9 −
Terminal block
cover mounting
screw
Pull the tab for opening the
front cover.
Front cover
Main unit panel
mounting screw
Plugging marks
on the wall
Air fi lter
2
1
Terminal
block cover
Cord
bushing
Main unit
panel
Installation
hole
Mounting screws
(5×30)
(Accessories)
Tab
Main unit
panel