Sealey VS0215 Quick Start Manual

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. Safety
Keep this product in good working order and condition, take immediate action to repair or replace damaged parts.
9
Use approved parts only. Unapproved parts may be dangerous and will invalidate the warranty.
9
Keep children and unauthorised persons away from the work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
ensure the work area has adequate lighting.
9
dO nOt use the kit to perform a task for which it is not designed.
8
dO nOt allow untrained persons to use the kit.
8
dO nOt use when tired or under the influence of drugs, alcohol or intoxicating medication.
8
After use, clean equipment and store in a cool, dry, childproof area.
9
dispose of waste liquids in accordance with local authority regulations.
9
Always read and comply with the warnings on the brake fluid container.
9
Wear eye protection and keep skin contact to a minimum. If brake fluid enters eyes rinse with plenty of water and seek medical
9
advice. If swallowed seek medical advice immediately.
WarninG! Only use new Brake Fluid, used Brake Fluid or other fluids will contaminate the system and possible brake system
‰
failure may result.
WarninG! dO nOt pollute the environment by allowing uncontrolled discharge of fluids.
‰
WarninG! Brake fluid is flammable - keep away from sources of ignition, including hot surfaces e.g. exhaust manifold.
‰
WarninG! Brake fluid will damage paintwork. Any spillage should be flushed with water immediately.
‰
WarninG! dO nOt allow the fluid capacity in the unit to fall below ½ litre during the bleeding process otherwise air may enter the
‰
system.
Always follow the vehicle service manual or consult a trained professional before starting.
9
Make sure the main tube adapter is firmly connected to the container.
9
Before starting, make sure the cap is firmly connected to the container.
9
Follow the recommended pressure in vehicle service manual. dO nOt exceed 20 psi in order not to damage the vehicles hydraulic
9
system.
When the pressure is too high, push the relief button to release the pressure and avoid any danger.
9
Never store the fluid in the container.
8
2. intrOductiOn
one-man professional pneumatic brake bleeding tool. Bleeding requires no manual effort only an air line, perfect for the busy workshop.
Reservoir holds 3ltrs of fluid after extraction, offers a clean method for an automatic discharge at the turn of a valve. Pressure range makes
unit suitable for use with ABS systems. Reservoir holds 3 ltrs, plenty to flush a whole system without the risk of running dry.
3. SPecificatiOn
Model no: ................................................................. VS0215
Inlet Size: ..................................................................1/2"BSP
Maximum Air Supply: ................................................113.8psi
nett Weight: .............................................................. 1.670kg
Tank Capacity: .................................................................. 3ltr
© Jack Sealey limited
Pneumatic Brake Bleeder
Model no:
Wear protective
gloves
Original Language Version
VS0215
VS0215 Issue 1 15/11/18