Advertisement
5.7
do not attempt to split a short log by pushing it with another log as one
of the logs may fly up and hit you.
5.8
do not attempt to free a jammed log by striking it with a hammer as
this may damage the machine or cause a sudden release of the log
which could be dangerous. see fig.5.
fig.5
5.9
When a log becomes jammed allow the log pusher to return to the
start position. Place a wedge under the jammed log and push the
wedge with the log pusher as shown below in fig.6. repeat the
process with progressively larger wedges until the log is freed.
fig.6
parts support is available for this product. to obtain a parts
listing and/or diagram,
please log on to www.sealey.co.uk, email sales@sealey.co.uk
or telephone 01284 757500.
important: no responsiBility is accepteD for incorrect Use of this proDUct.
Hydraulic products are only repaired by local service agents. We have service/repair agents in all parts of the uK.
DO NOT ReTuRN THe PRODucT TO us. Please telephone us on 01284 757500 to obtain the address and phone number of your local agent. If product is
under guarantee please contact your dealer. De-commissioning proDUct should the product become completely unserviceable and require disposal, draw
off the oil into an approved container and dispose of the product and the oil according to local regulations.
environmental protection.
recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging should be sorted,
taken to a recycle centre and disposed of in a manner which
is compatible with the environment.
NOTe: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
information: for a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack sealey limited
fig.4
sole UK Distributor, sealey group,
Kempson Way, suffolk Business Park,
Bury st. edmunds, suffolk,
IP32 7Ar
Original Language Version
6. maintenance
6.1
the hydraulic oil should be replaced after every 150 hours of use with
a good quality oil such as sealey HJo5lt.
6.2
ensure the log splitter is disconnected from the mains power supply.
6.3
Place a container with a minimum capacity of 4 litres up against the
front support leg and directly under the oil filler bolt with integral
dipstick (see fig.2-14).
6.4
remove the oil filler bolt with dipstick and tip the log splitter forwards
on the support leg so that the oil drains into the container as shown
below in fig.7-A.
6.5
tip the unit back on its wheels to a near vertical position and support it
in this position as shown in fig.7-B. refill the unit with 3 ½ litres of
hydraulic oil. drop the oil filler bolt with integral dipstick into the filler
hole and remove again to check the oil level which should be between
the two grooves on the dipstick.
6.6
screw the oil filler bolt back into the filler hole and fully tighten to avoid
leakage.
fig.7
7. troUBleshooting
symptom
possiBle caUse
log will not split.
log is not correctly
positioned
oil leak
Wedge cutting edge is
blunt
size or hardness of log
exceeds machine capacity
log pusher
lack of hydraulic oil
moves jerkily or
and excessive air in the
vibrates a lot.
hydraulic system.
oil leaks around
Air locked in hydraulic
cylinder ram or
system while operating
other points
Bleed screw not
tightened before
moving log splitter
oil drain bolt loose
Hydraulic control valve
assembly and/or seals
worn
Weee regulations.
dispose of this product at the end of its working life in compliance
with the eu directive on Waste electrical and electronic equipment.
When the product is no longer required, it must be disposed of in an
environmentally protective way. contact your local solid waste
authority for recycling information.
01284 757500
01284 703534
solUtion
refer to sections 5.3 to 5.5
contact service agent
Sharpen with fine tooth file
discard and split more suit-
able logs
top up oil / contact
service agent
loosen bleed screw by 3 to
4 rotations prior to operation
tighten before moving log
splitter
tighten oil drain bolt
contact service agent
www.sealey.co.uk
W e b
sales@sealey.co.uk
email
ls370H & ls520H
Issue: 3(I) - 30/10/13
Advertisement
